Friday, April 25, 2014

HP LaserJet 2015 Ethernet Conversion

So, I ordered a HP LaserJet 2015dn from ebay. The seller wasn't quite the worst at packing packages. (A contender, a close second for sure.) That in conjunction with the shipping company obviously using it for a few frames of bowling practice left it in the condition I received it in.

I obviously didn't learn anything from the encounter. After I got all my money back free and clear, I go ahead and order a second printer from the same seller. (Say it ain't so.) The second printer was a 2015d, i.e., no networking feature.

Feast your eyes on the photos below. The only changes are the stickers, a little removable plastic cover where the Ethernet plug gains entry to the device, and the formatter board. That last one being most important detail.

To save you a minute or two, pry the side panel off from the rear along the vertical edge. You'll need a #2 Phillips from there.




No comments:

Post a Comment

Followers